Skip to content
FYB

FYB FY-808 audio processor, 8 × 8

Model
FY-808
SKU
FYB-392278

Programmable matrix DSP processor with 8 analogue inputs and 8 outputs: sound processing, automatic mixer, USB playback and recording.

On order

Price on request

Send a request. A manager will name the price and the delivery time during working hours.

Key specifications

Power supply
AC 110~240 V, 50 Hz/60 Hz
Frequency response
±0.2 dB; ±0.2 dB Maximum level: +24dBu
All specifications

Description

The FYB FY-808 is a programmable matrix audio processor (DSP) with 8 analogue inputs and 8 outputs, sized for systems with a few microphones and zones. Microphone and source signals are processed digitally and sent through the matrix to the outputs where they are needed.

Digital processing

  • AGC (automatic gain control), AFC (feedback suppression), AEC (echo cancellation), ANC (noise reduction), AMC (automatic mixing).
  • Inputs: pre-amp with 0–43 dB gain, 48 V phantom power, signal generator, expander, compressor, 8-band parametric EQ, automatic mixer.
  • Outputs: 8-band EQ, delay, phase invert, crossover, five filter types, compressor.

Connections

  • Phoenix terminals, Mic/Line inputs.
  • USB: two digital PCM channels for playback and two for recording.
  • LAN, RS232 and RS485 for control, GPIO ports; control of third-party devices and camera tracking.
  • Software for Windows, iOS and Android: 16 scenes, multi-level user rights.

24-bit / 48 kHz conversion, latency under 3 ms, 113 dB dynamic range, 108 dB channel separation. 110–240 V mains. Processing is set up for the room during audio and public address installation.

Specifications

Communication
Interference rejection80 dB; 80 dB Channel isolation @1 kHz: 108 dB
Power
Power supplyAC 110~240 V, 50 Hz/60 Hz
Audio
Input impedance9.4KΩ; 20KΩ Output impedance (balanced connection): 102Ω System delay: <3ms
Frequency response±0.2 dB; ±0.2 dB Maximum level: +24dBu
Total harmonic distortion0.003% @4dBu; 0.002% @4dBu Dynamic range (analog channel): 113 dB
Crosstalk108 dB
Dynamic range113 dB
Sampling rate48K/24bit
Output levelOutput level: 0/-6 dB; Maximum level: +18dBu
Output impedance102Ω
Gain0/10/20/30/40/43 dB
Noise floorNoise floor (A-weighted-analog): -89dBu; Noise floor (A-weighted-Dante): -91dBu
Latency<3ms
Phantom power+48 V

FAQ

Why is audio processor needed in PA system?

Audio processor is essential in professional PA systems for several reasons: 1) acoustic correction – EQ eliminates room acoustic problems (resonances, echo), 2) feedback prevention – automatic feedback suppressor, 3) speaker protection – limiter protects speakers from excessive power, 4) zone control – matrix routing for different zones, 5) sound quality improvement – compressor, EQ, delay.

What's the difference between analog and digital audio processors?

Analog processors use analog circuits (op-amps, capacitors) – limited functionality, manual adjustment, noise. Digital processors (DSP) use digital signal processing – unlimited functionality (EQ, compressor, echo canceller, routing), PC/Mac software control, preset storage, precise parameters, no noise. Modern systems use only digital processors.

Can audio processor integrate with Dante network audio?

Yes, modern audio processors support Dante/AES67 network audio – this allows transmitting audio signals over IP network (LAN/WAN) without analog cables. Dante network provides low latency (<1ms), high quality (24-bit/96kHz), and simple scaling (hundreds of channels in one network). Integration: Dante audio processor + Dante amplifiers + Dante microphones + Dante mixer.

Need it installed?

LAGI will deliver, install and set up the equipment and provide warranty service afterwards.