Skip to content
3D render: hallway with an alarm keypad, a motion detector and a door sensor

Burglar alarm installation

A burglar alarm for houses, apartments, shops and warehouses: door, window and motion detectors, a siren and alerts to your phone.

What's included

  • Site walk-round

    We mark the doors, windows and rooms through which someone could get in, and choose a detector for each point.

  • Detector and siren installation

    We fit opening, motion and perimeter detectors, and indoor and outdoor sirens.

  • Control panel and power

    We install the alarm control panel with a backup battery in case of power cuts.

  • Alerts to your phone

    We set up GSM calls and SMS or app notifications, and check that they arrive.

  • Zones and modes

    We divide the site into zones: the ground floor can be armed at night while you are upstairs.

  • Training

    We show you how to set and unset the alarm with the keypad, a key fob or the app.

Burglar alarm installation in Tbilisi starts with a walk round the site: a LAGI engineer marks the doors, windows and rooms through which someone could get in, and decides which detector goes at each point. Contacts are fitted on the front door and ground-floor windows, motion detectors in corridors and rooms, and infrared beams around the grounds. When the alarm is triggered, the siren sounds and an alarm message is sent to your phone. The site survey in Tbilisi is free.

What makes up an alarm system

  • Alarm control panel – the unit all the detectors are connected to. The site is armed and disarmed through the panel, signals from the detectors arrive there, and the panel settings determine when the alarm goes off.
  • Detectors: magnetic contacts on doors and windows, motion detectors (PIR) in rooms, infrared beams for the perimeter, gas detectors in the kitchen and boiler room.
  • Sirens indoors and outdoors, often with a strobe so that the alarm can be seen from the street.
  • Controls – a keypad, a key fob or a phone app.

Wired, wireless or hybrid

WiredWirelessHybrid
Detector connectionCable to the panelRadio, for example ZigbeeCable for the main zones, radio where cable cannot be run
Detector powerFrom the panel via the cableBatteries, replaced every few yearsMixed
InstallationBest before the finishing work, or in trunkingNo chasing of wallsCable only where it is easy to run
Where it fitsA new house, office, warehouseA renovated apartment, a country house, rented premisesA finished house with grounds

A wired system does not depend on batteries or radio interference. A wireless system is quicker to install and easier to extend: a new detector is added without any cable.

How you find out about an alarm

The siren is there to scare intruders off and alert the neighbours. So that you know about the alarm too, a message is sent from the panel in one of these ways:

  • via GSM – a call or SMS through the SIM card in the panel; this works without internet at the site;
  • via the internet to an app – a push notification showing which detector was triggered;
  • through both channels at once: if the internet at the site goes down, the message goes out over GSM.

If the site has CCTV, after an alarm you can open the camera in the app straight away and see what is happening. There is more on this on our CCTV installation page.

Equipment we install

For wired systems we use SESAME detectors: magnetic contacts for doors, windows and gates, infrared beams for fences and yards, natural gas and LPG detectors. We also fit SESAME outdoor and indoor sirens and Heiman motion detectors. For wireless systems there are Heiman Zigbee smart sensors for door opening, motion, leaks and vibration, as well as a wireless siren and a panic button.

What affects the price

  • The number of doors, windows and rooms to protect, and whether there are grounds.
  • A wired or wireless system, the cable length and how it is laid.
  • The alert method: siren only, GSM, app, or all of them together.
  • Additional detectors: gas, leak, smoke.

After the survey you receive an estimate, and you can request a quote on our website.

Sites we work on

In a private house, the doors, ground-floor windows and grounds are protected. In a shop, it is the entrance, the shop window and the back room, and the alarm is set after closing time. In a warehouse, the gates, the perimeter and the office area. Smoke, gas and leak detectors can be connected to the same system or installed separately: fire protection is covered on our fire alarm installation page, and detectors for the home in the smart home section.

Warranty and maintenance

LAGI gives a warranty on the equipment and the installation work: the terms are set out in the contract, and the general conditions are on our warranty page. Before handover we test every detector and siren and show you how to set and unset the alarm. Batteries in the wireless detectors and the panel's backup battery are checked during maintenance.

How it goes

  1. 01

    Free site survey in Tbilisi

    We walk round the site, note the weak points and discuss a wired or wireless option.

  2. 02

    Layout and estimate

    We prepare a plan of zones and detectors, an equipment list and an estimate.

  3. 03

    Installation

    We lay the cable or fit wireless detectors, and install the panel and sirens.

  4. 04

    Testing and training

    We test every detector and the alerts, and show you how to use the system.

  5. 05

    Warranty and maintenance

    The system stays under warranty, and all batteries are checked during maintenance.

Equipment for this service

Products we install as part of this service.

Questions & answers

How much does burglar alarm installation cost?

The price depends on the number of zones and detectors, the choice between a wired and a wireless system, and the alert method. An alarm for an apartment with two or three detectors costs considerably less than a system for a house with grounds and infrared beams. We give the exact figure after a site survey, which is free in Tbilisi.

Does an alarm need a SIM card?

It does if you want to receive alarm calls and SMS via GSM. The SIM card goes into the control panel, and internet at the site is then not essential. If the site has a stable internet connection, notifications can come through an app. Two channels at once are the most reliable option: if the internet goes down, the message goes out over GSM.

Does the alarm work during a power cut?

Yes. The control panel runs on its built-in backup battery, and wireless detectors on their own batteries. Backup time depends on the battery capacity and the number of detectors connected, and we take it into account when choosing the equipment. A power failure can also be reported to you as a separate notification.

Will a cat or dog set off the alarm?

If a pet lives in the house, we install pet-immune motion detectors and choose the mounting position carefully. A cat or a small dog on the floor does not trigger these detectors. If a large dog jumps on the furniture, it is better to leave its room out of the protected area or to protect that room's doors and windows with contacts.

How do I set and unset the alarm?

With a code on the keypad by the entrance, a key fob or the phone app. The house can be divided into zones and partly armed: for example, at night the ground floor and garage are protected while the family is upstairs. At handover we set up the modes to suit your routine and show you how to use them.

Can gas and leak detectors be connected to the alarm?

Yes. Gas and leak detectors are connected to the same system as the intruder detectors, and the alert goes to the same phone. Our catalog includes wired SESAME gas detectors and wireless Heiman leak and gas detectors. A gas detector goes in the kitchen and the boiler room, and a leak detector next to the washing machine and the water heater.

Other services

Not sure what you need?

Book a free site survey in Tbilisi: an engineer walks the property with you and suggests a setup.